Jaj Busbar Systems
Power System in Pretoria

We are a Siemens Sivacon 8PS partner and we distribute, engineer and install Busbar systems all over Africa and in all types of industry.

Drastic reduction of cabling Tap-off points near the loads Flexible for modification and expansion ADVANTAGES OF BUSBAR. Connecting to building automation Unproblematic retrofitting in the event of load changes Low fire load (combustive energy) The CD-K system is ideally suited for the efficient power supply of lighting systems and small consumers of 25 A up to 40 A. in department stores, supermarkets or furniture stores. The plug-in quick connections are equipped to considerably facilitate installation. Since emergency and main power supply are combined in a single system, the busbar run is optimally utilized. Changes or expansions to the power distribution are possible quickly and easily without downtime using tap-off plugs that are pluggable when energized. The CD-K busbar trunking system can be connected to the GAMMA building management systems in order to realize energy-efficient solutions in lighting control. It is employed in trade and industry enterprises to safely supply small consumers with power or realise the infeed of the CD-K system. Planning is especially simple and it ensures a flexible power supply. The codable tap-off points and units can be clearly assigned to the consumers. The tap-off points are only automatically opened upon the tap-off units' connection. The tap-off units can be plugged into all system sizes. Feeder units can be used as incoming, end or center feeder unit. These two facts make both planning and stock keeping easier. Numerous components are available and so the power supply can be flexibly adapted to all building structures using 3D junction units. The compact system not only stands out for its safe operational behaviour, but also for its minimum space requirements. It can also be used for the infeed of the smaller CD-K and BD01 systems. The communication capable BD2 busbar trunking system with its load detection, remote monitoring and switching and its lighting control increases system availability and ensures greater transparency in your operation. With a high degree of protection of up to IP55, the system can also be used in heavily contaminated or damp environments. The aluminum enclosure gives rise to a low fire load and high corrosion resistance. It transports and distributes the power between the transformer, main power distribution board and sub-distribution boards on production sites with high power requirements, e.g. A separate PE busbar increases the conductor cross-section and ensures a low impedance in the event of faults. It facilitates longer busbar runs as well as an assured response of the protective device, also with long current paths. The high short-circuit strength and compact design open up many fields of application. The epoxy coating of the conductors offer additional protection against water in the ventilated system (IP34) (sprinkler-suitable). It is impervious to environmental factors such as air humidity and corrosive or salty atmospheres. With only minimum space requirements, it can be optimally adjusted to the construction conditions with angles, connectors and T-pieces for change of direction. The LR system is also perfectly suited for outdoor applications. The LR system can be simply and quickly fitted using the bolt-type terminal block. It is consistent and can be easily combined with the LX and LD systems for indoor applications.